Gitarové fórum A.D. 9.1.2004

EMG HZ je seria pasivnych snimacov od EMG, od H1 po H4 myslim ze su odstupnovane podla sily vystupu.
Pochybujem zeby nato Zakk hral, urcite hra na aktivnych, ale inac zaujimalo by ma ci ma niekto skusenost so snimacmi HZ-H4

mam, su ostre, pilkovite a hlave s vysokym vystupom. Kamarat ich mal v ESPcke a uspesne sa ich zbavil  :bravo:

nevie nahodou niekto z vas kolko ohmovy potenciometer na VOLUME treba k aktivnym snimacom EMG? Jak taky isty jak k pasivnym, tak ma zaujima hlavne ta hodnota odporu ;D

25k

k pasivnym idu vacsinou 250k single, 500k HB

hej, a ked mam jeden snimac aktivny a druhy pasivny, tak jaky tam mam potom potenciometer  :laugh:
Pozn. jako spravny spravny elektrotechnik nemam doma multimeter  :laugh:

Ja mam na pasivnych 500k, vymenil som za povodne 250k a ovela lepsi nabeh podla mna. Neriesil by som to vobec a dal tam 500k.
 :drink:

25k daj na aktivny a 500k na pasivny. pokial mas gitaru s minimalne dvoma potakmi. potom sa ale budes musiet zrieknut tonovej clony. ak mas iba jeden, tak si nahraty.. preto je dobre nekomplikovat si to a dat bud aktivky alebo pasivky

praveze ja mam len jeden potenciometer na hlasitost, a tonovu clonu nemam, a vyuzivam hlavne len ten aktivny tak asi tych 25k, ze?

500K na aktivny snimac je kokotina, aspon nerad sprostosti ;)  :drink:

Az som si otvoril Schecter zo zadu a pozeram, ze ma 500k vyrite na puzdre potaka. Kokotina, mas pravdu.  ;) :drink:

Az som si otvoril Schecter zo zadu a pozeram, ze ma 500k vyrite na puzdre potaka. Kokotina, mas pravdu.  ;) :drink:

Can I mix EMG’s with passive pickups?
It is possible to mix EMG’s with passive pickups. There are three possible wiring
confi gurations; one is better than the other two.
Use the high impedance (250K-500K) volume and tone contrgain and response.
Use the low-impedance (25K) volume and tone controls provided with the EMG’s. The
problem here is that the passive pickups will suffer a reduction in gain and loss of highfrequency
response.
This is the best alternative. Install an EMG-PA-2 on the passive pickups. There are
two benefi ts to doing this. With the trimpot on the PA-2, you can adjust the gain of the
passive pickups to match the EMG’s. The PA-2 acts as an impedance matching device
so you can use the low-impedance EMG controls (25K) without affecting the tone of the
passive pickups. You will also be able to use other EMG accessory circuits such as the
SPC, RPC, EXB, EXG, etc. For this application, we recommend ordering the PA-2 without
the switch for easy installation on the inside of a guitar.ols. The problem is that
the high impedance controls act more like a switch to the EMG’s. The passive pickups,
however, will work fi ne. If you have a guitar with two pickups and two volume pots, with
a three-way switch, there is another alternative. Use the 25K pots for the EMG, and the
250K pots for the passive pickup. This way you can use one or the other with no adverse
affects, but with the switch in the middle position the passive pickup will have reduced

Az som si otvoril Schecter zo zadu a pozeram, ze ma 500k vyrite na puzdre potaka. Kokotina, mas pravdu.  ;) :drink:

Neskusal niekto nahodou novu radu snimacov od EMG X-series? Pripadne viete niekto rozdiel medzi klasickymi aktivnymi snimacmi od EMG a X-series ? (napr. 707 vs. 707X)

Dik

Celkovo hovadina. Radsej nech preda tu akoze gitaru a kupi si za 500 EUR gitaru s normalnymi materialmi s tymito snimacmi. Aj tu na fore sa predavaju aj po bazaroch.

podla mojho nazoru v prvom rade asi bedna, potom aparat.

tieto cortky su celkom vydarene nastroje

Ten ich system zapojenia je skvela vec. Skoda, ze to nerobia aj ostatni vyrobcovia

Ak mi ide od kobylky kabel, je lepšie ju tiež uzemnit? Niekde som cital, že pri aktivkach sa neuzemnuje.